BOSS HM-2 Heavy Metal - no signal (included voltages in post)

[themachinerages]

I've been pulling out my hair trying to troubleshoot this HM-2 clone. I have no signal when engaged.

I'm using this layout which I have built before with success.

Here are photos of the board

I tested all of my resistors and capacitors beforehand. I'm using BF244A in place of the BF245 (last one I built that worked I used a BF245B). I'm using TL072CP op amps. I tested with several of each transistor / op amp to make sure one isn't faulty

As someone pointed out when I posted on Reddit (/r/diypedals), I had the 244 oriented wrong (had to switch S and G, then rotate 180) in that photo but I have adjusted and updated the voltages. Still no signal.

You might notice one spot where I made an accidental cut and added a link to fix this on the solder side of the board

I measured the DC voltage to ground:

IC1 (top on layout)

1- 7.9
2- 1.4
3- 4.0
4- 0
5- 3.3
6- 3.3
7- 0.7
8- 8.5

IC2

1- 7.9
2- 7.9
3- 1.3
4- 0
5- 4.0
6- 4.1
7- 4.1
8- 8.5

IC3

1- 4.0
2- 4.1
3- 3.9
4- 0
5- 4.0
6- 4.1
7- 4.1
8- 8.5

BF244A

G- 3.7
S- 5.0
D- 8.5

C2240

E- 0
C- 4.2
B- 0.5

A970

E- 7.7
C- 3.3
B- 7.1

Let me know if I can provide anything else or clarify something

[Frank_NH]

The voltages on IC1 and IC2 look wrong, specifically pins 1-3, 5-7 on IC1, and 1-3 on IC2.  They should all look like IC3, with ~4 to 4.5 volts on pins 1-3, 5-7.  It may be a solder bridge or an incomplete (missing) cut.