Bazz Fuss - Layout question.

[spacefuzz74]

Hey all.  for the attached layout, it should be:

Vol2>Out
Vol1>GND

right?  instead of Vol3>GND?

it's an easy layout, but i can't get this thing working!

thanks for any input!

[rocket88]

correct. in the bazzfuss and most effects the volume pot will be wired so volume 1 goes to ground, volume 3 is connected to signal on the board, and volume 2 is the output to the switch. in the layout you provided volume 3 is not wired to ground but to the output cap.

[spacefuzz74]

thank you for the response!  i thought that leg one usually went to GND, but just wanted to make sure.

it ended up, in the end, that i had a cap leg in the wrong row...bah.  

[rocket88]

yea that happens. you can actually put lug 3 on ground and lug 1 to the output signal on the board, and keep lug 2 to the output switch. if you did that the only thing that will happen is that you're volume pot will work backwards.