Maxon OD808 Reissue: Low Output Issue

[Patrick1904]

Hi all.

Having an output issue with my OD808 Reissue build. Very low volume when effect is engaged, full signal while bypassed. LED lights up. IC gets hot to the touch.

Layout:
https://tagboardeffects.blogspot.com/2013/03/maxon-od808-reissue.html?m=1

Offboard Wiring:
http://tagboardeffects.blogspot.com/2012/02/offboard-wiring.html?m=1

IC: JRC4558
Datasheet: https://img.ozdisan.com/ETicaret_Dosya/408213_9227758.pdf

Measured:
1 8.40    8 8.90
2 8.37    7 8.90
3 8.30    6 8.87
4 0.       5 8.32

Transistors: 2N5088
Datasheet:
https://www.onsemi.com/pub/Collateral/2N5088-D.PDF

Measured:
Top Left
C 8.89
B 5.56
E 5.21

Bottom
C 8.97
B 5.57
E 5.22





This was my first build and I can’t seem to get it working, any help would be greatly appreciated. Thanks!

[Marbles]

I'm sorry, I haven't had a lot of time to look at it. But could you check the link next to your ceramic capacitor? It looks as if it's one row too high

-edit-

Judging the bottom that link is correct, sorry. Is the link under the IC correct? I know it sounds obvious, but could you knife all the tracks again to make sure and check if all the cuts are fully cut? The orientation seems fine to me