Hello,
Enclosed description and photographs of the test bench that I have achieved.
It is based on the Beavis board.
1 Plywood 500 x 500 X 10 mm
4 plastic adjustable feet
5 + 1 carved breadboards
1 box (beavis board) + 1 display with a voltage interuptor on / off
+ 1 switch SPDT compared to the original
I 've replaced the 3PDT Footswitch 3PDT a toogle
1 Box for diferent potentiometers (22 Potentiometer in my case)
1 small box with 1 DPTD on / on
1 DPTD on / off / on
1 MSR on / off / on
1 display with a voltage interuptor on / off to measure
the voltage to n 'anywhere in the circuit.
1 decade resistor (ebay)
2 decades capacitors (ebay)
1 Component Tester (ebay)
7 terminals
three 9-volt battery holders that I have placed under the plywood
A box with cables :)
The 4 adjustable feet allow to raise the bench éssai to pass cables
and batteries below.
By cons I have not roved good solution for all these terminals potentiometers.
That's why I have finally cut a breadboard for me to use terminal.
It was painful because I have soldered the components legs on cables.
Here I put pictures more but if you can see it in action on the demo
Video of the overdrive flapjack.
I hope that google translation has worked well :)
Thank you @ +