Timmy diode switch question.

[DannyBoy]

I have a question about the most recent compact layout. How will I wire up the additional diodes switch ? Do I run wire from the board drive 1to the drive pot, then have the switch between lugs 1 & 3 on the pot, then back to the board from lug 3? Then obviously run drive lug 1 to the treble pot 2 &3.

[nocentelli]

Yes, just as you described. This means you need to have three wires connected to drive lug 1 (to the board, to the switch, to treble 2+3) and two wires connected to drive 3 (to board and switch)

[MOPO]

Hello,

It is also necessary to reverse the threads in relation to the shemas
DRIVE 1 TO TREB 1 and 2
TREB 3 instead of TREB 1
BASS 1 and 2 in place of BASS 1
BASS 3 has the place of BASS 2 and 3
If you want to have the pots in the right clockwise direction.