Where is the output on the board layout?

[THE-ElBaRtO]

Hey guys,

It's the second time I try to make my own pedal and I chose to make an oxblood distortion pedal using the layout I found here: http://tagboardeffects.blogspot.fr/2012/05/hipkitty-oxblood-distortion.html

But there is something confusing on the layout: the position of the "Input" cable is shown but not the output one...It may be a silly question but is it because the "Volume 3" on the layout correspond the output ? The "Volume 3" cable goes to the volume pot and then comes out of the Volume 2 to the output jack. Is that how it works ?

Thanks for your help

[PMowdes]

There should be a wire from the board to volume 3.

There should be a wire from volume 2 to the output.

Volume 1 goes to ground.

Output goes through the main stomp switch to the output jack.

Check the off board wiring tab on the main page.

[THE-ElBaRtO]

I understand that you're describing this offboard tab: http://1.bp.blogspot.com/-k5Sh68yVU18/TzGRFKbiALI/AAAAAAAAAlk/CbfaaduUjYQ/s1600/%21Offboard+wiring.png
What I don't understand from this tab is that there is a clear "Output" labeled coming from the board, but there is none on the oxblood pedal distortion layout.

[PMowdes]

In this case there is no direct output from the board,  the output comes from volume potentiometer lug 2

[THE-ElBaRtO]

Alright it's a lot clearer in my head now, thank you very much for your time !