Maestro FZ-1b (2 transistor version)

[anders]

Hi!
I've been tinkering with the 2 transistor silicon version fuzz from Maestro. The balance control does nothing and the output is quite low. A second set of experienced eyes would be appriciated.

[anders]

Got it working.
It was a faulty pot, so it is verified.

On to the next one

[Neil mcNasty]

Hello again Anders!

Just a quick tip:
If you go to the "edit" menu in DIYLC, you wil find setting for the size of your work area all the way at the bottom of the menu.
I allways start by going there and setting the size to about 12x12cm as a start and increase it if needed as I go.
That way you will avoid the enormous amount of dead space in your layouts when exporting the finished result.

Thanks for sharing!
Neil

[anders]

Ok, thanks for the tip!

[Sanchozen]

Newb here. How do I wire this to a 3pdt as done this way instead of a Spdt?
Also, can you confirm orientation of the transistors?

Thanks!

[Bolsyo]

[Sanchozen]

On the right side of the board I’m just not sure where to attach switch 1 and switch 2 (which also goes out to vol 1). I’m assuming Switch 1 goes to either input or output on the footswitch and the same for Switch 2. On the left of the board is an input so I’m confused!


Chris

> On Nov 5, 2020, at 2:35 PM, Bolsyo [via Guitar FX Layouts] <[hidden email]> wrote:
>